As for the contact switch.... after installing the device, it didn't appear to do anything. I used your "Z-Wave Watcher" plugin to then track the device and see that it was sending raw zwave reports when I open, close or remove the back cover (tamper)......
So, using an open and close trigger on the received raw zwave to modify a variable I then created a virtual device to represent the state. <-- That's a lot of crap to use one simple device.
While searching the forum on stuff (keypad, zwave, RFID and some other keywords on projects I'm working through), I came back to this plugin (Which has been controlling my Yale door lock flawlessly for a couple years now) and noticed you have door/window and keypads in the description.
I created a new ZWave Lock Manager device for the contact switch, using model "Door Lock" (I didn't see any other options).... It recognizes the switch, but I only get a status change on "open" (Event:2) even though the plugin sees "close" (Event:0). Any ideas?
- Code: Select all
Trigger Bill's Gun Safe Open
Z-Wave Watcher Debug Raw command received (Node 44): 01 0F 00 04 00 2C 09 71 05 00 00 00 FF 07 02 00 5F
Z-Wave Lock Manager Debug Node ID 44 (Hex 44) found in lockIDs
Z-Wave Lock Manager Debug -----
Z-Wave Lock Manager Debug Lock Status Report received:
Z-Wave Lock Manager Debug Raw: 01 0F 00 04 00 2C 09 71 05 00 00 00 FF 07 02 00 5F
Z-Wave Lock Manager Debug Node: 44
Z-Wave Lock Manager Debug Type: 7
Z-Wave Lock Manager Debug Event: 2
Z-Wave Lock Manager Status: Intrusion alert [Node: 44]
Trigger Bill's Gun Safe Close
Z-Wave Watcher Debug Raw command received (Node 44): 01 10 00 04 00 2C 0A 71 05 00 00 00 FF 07 00 01 02 42
Z-Wave Lock Manager Debug Node ID 44 (Hex 44) found in lockIDs
Z-Wave Lock Manager Debug -----
Z-Wave Lock Manager Debug Lock Status Report received:
Z-Wave Lock Manager Debug Raw: 01 10 00 04 00 2C 0A 71 05 00 00 00 FF 07 00 01 02 42
Z-Wave Lock Manager Debug Node: 44
Z-Wave Lock Manager Debug Type: 7
Z-Wave Lock Manager Debug Event: 0