So I'm using the somfy to insteon bridge that has been working really well - I believe it uses a preconfigured IOLinc
While the drape control works awesome on timers and other trigger actions I can't get it to behave correctly inside a control page
When I start with the blinds open and I touch the button it correctly shuts the blinds and correctly updates the control page button state and I get the following:
Sent INSTEON "Studio Blinds" off
Sent INSTEON "Studio Blinds" status request (received input sensor: open)
Sent INSTEON "Studio Blinds" status request (received output relay: off)
So far so good. Except when I now go to open them again and touch the blinds button again I get the exact same event logs and everything is stuck with the shades being closed:
Sent INSTEON "Studio Blinds" off
Sent INSTEON "Studio Blinds" status request (received input sensor: open)
Sent INSTEON "Studio Blinds" status request (received output relay: off)
My control page button is set up like this:
Display: "Device State" Device: "Studio Blinds" then with "Binary Output 1"
I've also tried fiddling with the Studio Blinds IOLinc settings to no avail
Anyone have any ideas?
Thanks in advance!
-Bob